morse logo
The Specialist In Drum Handling EquipmentPhone: (315) 437-8475       Fax: (315) 437-1029

Rack horizontal drum with Morse Omni-Lift Drum RackerRack Configuration

Typical rack configuration served with Morse Omni-Lift TM Drum Rackers

Omni-Lift TM drum rackers rack drums as shown on drum rack below. Approximate outside diameter of 24" O.D. of a standard 55-gallon steel drum is at the largest rim or rib. Move drum cradles on the drum rack into position to meet your drum racking requirements. Additional drum cradles are usually available separately.

Omni-Lift racker drum spacing
NoteNOTE: Morse does NOT make or sell the drum rack. Morse manufactures drum rackers to place a drum into and retrieve a drum from a drum rack.

Rack Configuration for Morse 405 Series Omni-Lift Drum Rackers
Please note that, using the Omni-Lift TM Drum Rackers, the minimum clearance between drums is 8". Omni-Lift TM drum rackers can be used to rack drums up 6 feet high.

To rack drums virtually side by side, and up to 8.5 feet high, see the rack configuration for MORStak TM Drum Rackers.

Back to Omni-Lift Drum Rackers

Last Updated: 03/13/19

 
California Proposition 65 Information
warning iconWARNING: This product can expose you to chemicals including barium sulfate, cobalt, titanium dioxide, and 2-methylimidazole, which are known to the State of California to cause cancer, and bisphenol-A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov