Bead Blast Stainless Steel Clamp Collar to secure Drum Cone to drum.

Clamp Collar to secure cone to drum. Steel rods retain Drum Cone. Angle iron engages UNDER top rim of drum.

Model 7SS-19

Stainless Steel Clamp Collar to Secure Drum Cone to Drum Top. Fits 19-1/8" (48.6 cm) drum rim outside diameter with drum lid removed.

All about Model 7SS-19

Specific to Model 7SS-19

Made of bead blast finished Type 304 Stainless Steel
Clamp Collar secures Drum Cone to drum
Fits 19-1/8" (48.6 cm) drum rim outside diameter
IMPORTANT: Remove drum lid. Then measure drum top rim outside diameter WITHOUT lid.
Sized for typical 30-gallon (114 liter) steel drum
Tighten Clamp Collar around top rim of drum with Cone in place
Tighten Clamp Collar by turning knob on end of threaded rod
On inside of Clamp Collar, sections of rod retain Cone, and sections of angle engage under top rim of drum

All Drum Cones

Replace your drum lid with a drum cone
Control dumping of DRY MATERIAL from a drum
Greatly reduce dust when discharging dry material
Extend the reach of pour
Install either a slide gate or an iris valve with 6" (15.24 cm) opening to start and stop dispensing
Drum cones work with a steel drum or a fiber drum
Drum Cone capacity exceeds the capacity of all Morse drum handlers when properly secured to drum with correct size Morse Clamp Collar
IMPORTANT: Determine the Correct Size Drum Cone and Clamp Collar
1. Remove drum lid BEFORE measuring
2. Measure drum OUTSIDE diameter across Top Rim WITHOUT drum lid

No options available.

Not available.

4-digit serial numbers are simply the month & year of manufacture.
Example: 1120 is November 2020

1Spec Sheet

No videos available.